Deutz 914 Specifications download pdf (Page 22)

Operation Start procedure

with cold starting device

Insert key.

– Position 0 = no operating voltage.

Turn key to the right.

– Position 1 = operating voltage.

– Pilot lamps (A), (B) and (C) light up.

stage 2 = pre-heating

– Preheat until the glow display goes out; an

error has occurred if the preheating indicator

flashes; e.g. the preheating relay is stuck,

which can discharge the battery completely

when at a standstill.

– Engine is ready for operation.

Push the key in and turn further clockwise

against spring pressure.

– Level 3 = start.

release the key as soon as the engine starts up.

– The pilot lamps will go out.

After starting, any exhaust gas turbidity in

the runup phase can be reduced by holding

the key at stage 2. (maximum 3 minutes)

OBJ_DOKU-16314-001.fm Seite 22 Donnerstag, 24. Juli 2008 11:18 11

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

No comments

Deutz 914 Specifications Page 22