Deutz 914 Specifications download pdf (Page 52)

Faults Fault table

Engine output is deficient Lube oil level too high Check lube oil level, if necessary drain off.

Lubricating oil level too low Fill up lube oil

Lubricating oil cooler fins soiled Clean

Engine stop lever still in stop position Stop magnet defective (release circuit)

Fuel suction temperature too high Check the system

Fuel quality does not comply with operating manual Change the fuel

Air filter clogged / turbocharger defective Check/replace

Air filter maintenance switch / maintenance indicator defective Check/replace

Fan defective/V-rib belt torn or loose Check fan/V-belt, change if necessary

Charge air line leaking Check charge air line

Charge air cooler soiled Clean

Heat short-circuit in the cooling air guidance Check the cooling system

Resistance in cooling system is too high / flow volume too low Check the cooling system

Injection line leaks Check injection line

Injection valve defective Check fuel injector

Engine stop lever still in stop position Check/replace

Engine does not run on all cylinders Injection line leaks Check injection line

Injection valve defective Check fuel injector / change if necessary

Incorrect valve clearance Settings

Compression pressure too low Check the system

Fuel filter/fuel pre-cleaner contaminated (lamp/siren faulty) Empty/clean/change

Air in fuel system Vent fuel system

Faults Causes Measures

OBJ_DOKU-16314-001.fm Seite 52 Donnerstag, 24. Juli 2008 11:18 11

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

No comments

Deutz 914 Specifications Page 52